Isis-proteus-7-7 -

: Give your component a unique name (e.g., "MY_CHIP_77").

Place pins on the edges of your 2D box. You can rotate them (using the keypad + or - ) so the connection point faces outward. : Double-click each pin to open the Edit Pin dialog. isis-proteus-7-7

: If a similar component exists, place it, right-click, and select Decompose . Modify the pins or graphics, then follow the "Make Device" steps above to save it as a new version. : Give your component a unique name (e

: Click Next to link a PCB footprint (from ARES) if you plan to design a board later. Save to Library : : Double-click each pin to open the Edit Pin dialog

Use the to draw a box around your entire drawing (box and pins). Right-click the selection and choose Make Device . Configure Device Properties :

Select a (e.g., "Analog ICs") and a Library (usually "USERDVC") to store it.