If you are measuring the output pins, you should see approximately: : Powers the processor and memory. 5V : Logic circuits and USB (if applicable). 12V : Audio and switching. 22V / 30V : LNB power (tuner voltage).
The satellite receiver (part of the General Satellite family) typically uses a pulse-width modulation (PWM) power supply, often based on the DM0265R or DM0365R chip. These units are known for common failure points due to heat and aging. Common Schematic Block Components
: Check the SR360 or similar Schottky diodes on the secondary side. If the receiver is completely dead, these are likely shorted.
The power supply block (PSU) generally follows this architecture:
on the output lines often dry out, causing the receiver to "boot loop" or fail to turn on.